高级检索
    韩雪飞, 邹祺, 曾涛, 杨晓波, 曹剑武. (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06) O3压电陶瓷及蜂鸣器的制备与性能[J]. 机械工程材料, 2017, 41(2): 55-58,62. DOI: 10.11973/jxgccl201702011
    引用本文: 韩雪飞, 邹祺, 曾涛, 杨晓波, 曹剑武. (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06) O3压电陶瓷及蜂鸣器的制备与性能[J]. 机械工程材料, 2017, 41(2): 55-58,62. DOI: 10.11973/jxgccl201702011
    HAN Xue-fei, ZOU Qi, ZENG Tao, YANG Xiao-bo, CAO Jian-wu. Preparation and Property of (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06)O3 Piezoelectric Ceramics and Ceramic Buzzer[J]. Materials and Mechanical Engineering, 2017, 41(2): 55-58,62. DOI: 10.11973/jxgccl201702011
    Citation: HAN Xue-fei, ZOU Qi, ZENG Tao, YANG Xiao-bo, CAO Jian-wu. Preparation and Property of (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06)O3 Piezoelectric Ceramics and Ceramic Buzzer[J]. Materials and Mechanical Engineering, 2017, 41(2): 55-58,62. DOI: 10.11973/jxgccl201702011

    (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06) O3压电陶瓷及蜂鸣器的制备与性能

    Preparation and Property of (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06)O3 Piezoelectric Ceramics and Ceramic Buzzer

    • 摘要: 采用固相烧结法制备了φ15 mm×0.1 mm的(Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06)O3压电陶瓷,研究了其微观结构、电学性能以及热退极化性能;将该陶瓷封装制成蜂鸣器,测试了其声学性能并与市购铅基蜂鸣器进行了对比。结果表明:该陶瓷具有单一的四方相钙钛矿结构,在低于其居里温度(265℃)条件下的压电常数、机电耦合系数分别约为280 pC·N-1,达到未升温陶瓷的89.2%,温度稳定性好;在1~4 kHz、9 V交流电条件下,由该陶瓷组装的蜂鸣器的声压级略小于铅基蜂鸣器的,在2 kHz、3 V条件下则大于铅基蜂鸣器的,且该蜂鸣器在-40~85℃的声学性能稳定。

       

      Abstract: (Na0.52K0.44Li0.04)(Nb0.9Sb0.04Ta0.06)O3 piezoelectric ceramics with size of φ15 mm×0.1 mm was prepared by solid-state sintering method, and then the microstructure, electrical property and thermal depolarization property of the ceramics were studied. The ceramics were packaged into a buzzer and the acoustic property of the buzzer was measured and compared with that of the commercial lead-based one. The results show that the ceramics had the pure perovskite phase (tetragonal) structure. Below the Curie temperature (265℃), the piezoelectric constant were about 280 pC·N-1 and reached 89.2% that of the unheating ceramics, indicating the good temperature stability. The sound pressure level of the buzzer made of the ceramics was slightly lower under the conditon of (1-4) kHz/9 V while better under the condition of 2 kHz/3 V than that of the lead-based one. Moreover, the acoustic property of the ceramic buzzer kept stable at temperatures between -40℃ and 85℃.

       

    /

    返回文章
    返回