双辊铸轧对热轧Mg-5.45%Al-1.36%Si镁合金板组织和性能的影响

基金项目:

国家“973”计划资助项目(2007CB613706)

详细信息

Effect of Twin Roll-casting on Microstructure and Performance of Hot Rolling Mg-5.45%Al-1.36%Si Magnesium Alloy Plate

摘要: 利用双辊铸轧法成功铸轧出了5 mm厚的Mg-5.45%Al-1.36%Si共晶镁合金板,研究了镁合金铸轧板的组织及其对后续热轧镁合金板组织及性能的影响.结果表明:镁合金铸轧板的显微组织均匀,基本为细小的枝晶,明显优于普通铸造组织;再热轧后,板材的再结晶程度、晶粒细化效果、抗拉强度随着热轧压下率的增加而提高.
- 双辊铸轧 /
- 热轧 /
- 镁合金
Abstract: Mg-5.45%Al-1.36%Si eutectic magnesium plate of 5 mm thick was produced successfully by the twin roll-casting technology.The effect of roll-casting Mg alloy plate microstructure on the microstructure and mechanical properties of the subsequent hot rolling Mg alloy plate was studied.The results show that the microstructure of the roll-casted Mg alloy plate was homogeneous and small dendrites.The tensile strength,degree of recrystallization and refinement increased with increasing the rolling reduction.
- twin-roll casting /
- thermal deformation /
- Mg alloy

[1]	YIN D L,ZHANG K F,WANG G F,et al.Warm deformation behavior of hot-rolled AZ31 Mg alloy[J].Materials Science and Engineering A,2005,392:320-325.
[2]	KIM S H,SEO Y M,YIM C D,et al.The effect of rolling conditions on the microstructure and texture evolution of AZ31 Mg alloy sheets[J].Materials Forum Volume,2005,29:530-535.
[3]	BARNETT M R,KESHAVARZ Z,NAVE M D.Microstructural features of rolled Mg-3Al-1Zn[J].Metallurgical and Materials Transactions A,2005,36(7):1697-1704.
[4]	WATARI H,KOGA N,PAISARN R,et al.Formability of magnesium alloy sheets manufactured by smi-solid roll strip casting[J].Materials Science Forum,2004,449/452:181-184.
[5]	张士宏,许沂,王忠堂,等.镁合金成形加工技术[J].世界科技研究与发展,2001,23(6):18-21.
[6]	娄花芬,李周,李宏磊,等.变形镁合金连续铸轧技术研究进展[J].材料导报,2005,19(4):58-60.
[7]	王渠东,丁文江.镁合金及其成形技术的国内外动态与发展[J].世界科技研究与发展,2004,26(3):39-46.
[8]	WATARI H,DAVEY K,RASGADO M T,et al.Semi-solid manufacturing process of magnesium alloys by twin-roll casting[J].Journal of Materials Processing Technology,2004,155/156:1662-1667.