高级检索
    王宁, 余圣甫, 余阳春, 杨可. 两种硬面药芯焊丝堆焊层金属耐磨性的研究[J]. 机械工程材料, 2006, 30(8): 57-60.
    引用本文: 王宁, 余圣甫, 余阳春, 杨可. 两种硬面药芯焊丝堆焊层金属耐磨性的研究[J]. 机械工程材料, 2006, 30(8): 57-60.
    shu
    WANG Ning, YU Sheng-fu, YU Yang-chun, YANG Ke. Wear Resistance of Two Types of Hard-facing Cored Welding Wire[J]. Materials and Mechanical Engineering, 2006, 30(8): 57-60.
    Citation: WANG Ning, YU Sheng-fu, YU Yang-chun, YANG Ke. Wear Resistance of Two Types of Hard-facing Cored Welding Wire[J]. Materials and Mechanical Engineering, 2006, 30(8): 57-60.
    shu

    两种硬面药芯焊丝堆焊层金属耐磨性的研究

    Wear Resistance of Two Types of Hard-facing Cored Welding Wire

      摘要
    • 摘要: 对研制的两种硬面药芯焊丝HDY704、HDY502焊态和焊后热处理堆焊层金属的显微组织及耐磨性能进行了研究,探讨了堆焊层金属的磨损机理.结果表明:合金钢硬面药芯焊丝HDY704和不锈钢硬面药芯焊丝HDY502堆焊层金属的显微组织均为马氏体加少量残余奥氏体;焊后热处理均能提高其耐磨性能;热处理后HDY502堆焊层金属有弥散碳化物析出使硬度增加近10 HRC,而HDY704堆焊层金属的硬度不变;堆焊层金属的磨损机理为沙粒在压力作用下被压入基体中沿运动方向的切削破坏.

       

      Abstract: The microstructure and wear resistance of the overlaying welding metal of two new types of hardfacing flux-cored wire HDY704 and HDY502 were studied.Wear resistance of the overlaying welding metal was analyzed before and after heat treatment.The microstructure of the welding metal of HDY704 and HDY502 was martensite and residual austenite.Postweld heat treatment increased wear resistance.The hardness of the overlaying welding metal of HDY502 was increased by 10 HRC,which was caused by the disperse precipitation of carbides.The hardness of the overlaying welding metal of HDY704 remained constant with no disperse precipitation of carbides.The mechanism of wear resistance of the hardfacing overlaying welding metal was cutting damage of sand grains pressed into base metal by vertical stress component in the direction of moving orientation.

       

      • HTML全文
      • 参考文献(5)
      • 相关文章
      • 施引文献
    • 资源附件(0)

    /

    返回文章
    返回