高级检索
    杨咏东, 李剑平, 张骏. 氧化铝模板二步法制备工艺的改进[J]. 机械工程材料, 2007, 31(4): 66-67.
    引用本文: 杨咏东, 李剑平, 张骏. 氧化铝模板二步法制备工艺的改进[J]. 机械工程材料, 2007, 31(4): 66-67.
    shu
    YANG Yong-dong, LI Jian-ping, ZHANG Jun. A New Method for Preparation of Alumina Oxide Template[J]. Materials and Mechanical Engineering, 2007, 31(4): 66-67.
    Citation: YANG Yong-dong, LI Jian-ping, ZHANG Jun. A New Method for Preparation of Alumina Oxide Template[J]. Materials and Mechanical Engineering, 2007, 31(4): 66-67.
    shu

    氧化铝模板二步法制备工艺的改进

    A New Method for Preparation of Alumina Oxide Template

      摘要
    • 摘要: 采用两步氧化法制备多孔氧化铝模板,讨论了电压对模板质量的影响,并用扫描电镜对其进行了表征.结果表明：所得模板的孔洞均匀、有序,其典型的孔径为40~70 nm,孔间距在110 nm左右.

       

      Abstract: Anodic aluminum oxide template was prepared by a two-step method and the effect of voltage on the template was discussed and the appearance of the template was analyzed with SEM. Both the distribution and the size of the pores are regular.The pore size is about 40-70 nm and the pores spacing is about 110 nm.

       

      • HTML全文
      • 参考文献(4)
      • 相关文章
      • 施引文献
    • 资源附件(0)

    /

    返回文章
    返回